Altima V6-3.5L (VQ35) (2003)
7.
Apply heat and solder to the terminal as shown in Figure 7.
^
Apply solder to end of the crimp on the exposed wire strands.
^
Use high quality thin rosin-core solder, such as Radio Shack item # **0.032" dia., 2.5 oz, 60/40 (Lead/Tin), rosin-core solder or equivalent.
IMPORTANT:
^
Clean/brush off any loose pieces of solder.
^
Use the OK / NG photos shown below as a guide to make sure the solder is applied correctly.
NG:
This is a "cold" solder. The solder did not flow into the crimp and between the wire strands.
NG: