Altima V6-3.5L (VQ35) (2003)
CAUTION:
^
After drive shaft has been assembled, ensure that it moves smoothly over its entire range without binding.
^
Use NISSAN Genuine Grease or equivalent after every overhaul.
Transaxle Side (D95 type)
1. Install boot and new small boot band on drive shaft. Cover drive shaft serration with tape so as not to damage boot during installation.
2. Install ball cage, inner race and balls as a unit, making sure the marks which were made during disassembly are properly aligned.
3. Install new snap ring.
4. Pack drive shaft with specified amount of grease.
5. Install slide joint housing, then install new snap ring.
6. Make sure that boot is properly installed on the drive shaft groove.
Set boot so that it does not swell and deform when its length is "L2".
Length "L2" : 95.1 - 97.9 mm (3.74 - 3.85 inch)