Altima V6-3.5L (VQ35) (2003)
^
Apply (wrap) four layers of vinyl (electrical) tape around the Flange Bracket (see Figure 1). This will help prevent contact/rubbing
between the Flange Bracket and the Console Boot.
4.
Apply a few drops of High Temp High Strength Threadlocker Red* to the shift lever threads.
*
Use Nissan P/N 999MP-AM004P. Details are covered in the PARTS INFORMATION section.
5.
Reinstall (or replace if needed) the Shift Knob.
^
Make sure the gear shift numbers and the knob are in the proper position (NOT slanted).