Altima V6-3.5L (VQ35) (2003)
/Page-2267001.png)
Back Window Glass: Service and Repair
Rear Window Glass and Molding
REMOVAL
1. Remove the rear of the headliner.
2. Remove the rear pillar garnish. Refer to "BODY SIDE TRIM".
3. Remove the rear parcel shelf finisher.
4. Remove the connectors and grounds for the rear window defogger and printed antenna.
-
After removing moldings, remove glass using piano wire or power cutting tool and an inflatable pump bag.
-
If a windshield glass is to be reused, mark the body and the glass with mating marks.
WARNING: When cutting the glass from the vehicle, always wear safety glasses and heavy gloves to help prevent glass splinters from entering
your eyes or cutting your hands.
CAUTION:
-
When a windshield glass is to be reused, do not use a cutting knife or power cutting tool.
-
Be careful not to scratch the glass when removing.
-
Do not set or stand the glass on its edge. Small chips may develop into cracks.
INSTALLATION
-
Use a genuine Nissan Urethane Adhesive Kit or equivalent and follow the instructions furnished with it.
-
While the urethane adhesive is curing, open a door window. This will prevent the glass from being forced out by passenger compartment air
pressure when a door is closed.
-
The molding must be installed securely so that it is in position and leaves no gap.
-
Inform the customer that the vehicle should remain stationary until the urethane adhesive has completely cured (preferably 24 hours). Curing time
varies with temperature and humidity.
WARNING:
-
Keep heat and open flames away as primers and adhesive are flammable.
-
The materials contained in the kit are harmful if swallowed, and may irritate skin and eyes. Avoid contact with the skin and eyes.
-
Use in an open, well ventilated location. Avoid breathing the vapors. They can be harmful if inhaled. If affected by vapor inhalation,
immediately move to an area with fresh air.
-
Driving the vehicle before the urethane adhesive has completely cured may affect the performance of the windshield in case of an
