Altima V6-3.5L (VQ35) (2003)
7. Remove the partition sash from the glass run.
8. Remove the partition sash mounting bolt (lower) and screw (upper) to remove the sash.
9. Remove the glass from the inside of the panel.
10. Remove the partition glass from the panel.
INSTALLATION
Install in the reverse order of removal.
INSPECTION AFTER REMOVAL
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
-
Gear wear
-
Regulator deformation
-
Spring damage
-
Grease condition for each sliding part
The arrows in the figure show the application points of the grease "Dow Corning Moly Coat SK 623".
FITTING INSPECTION
-
Check that the glass is securely fit into the glass run groove.
-
Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. If the clearance between the
glass and sash is not parallel, loosen the regulator mounting bolts, guide rail mounting bolts, and glass and carrier plate mounting bolts to correct
the glass position.