Altima 2.5 L4-2.5L (QR25DE) (2002)
Brake Switch (Cruise Control): Initial Inspection and Diagnostic Overview
Component Inspection
ASCD BRAKE SWITCH
1. Turn ignition switch "OFF".
2. Disconnect ASCD brake switch harness connector.
3. Check continuity between ASCD brake switch terminals 1 and 2 under the above conditions.
If NG, adjust ASCD brake switch installation, refer to "BRAKE PEDAL" and perform step 3 again.
STOP LAMP SWITCH
1. Turn ignition switch "OFF".
2. Disconnect stop lamp switch harness connector.
3. Check continuity between stop lamp switch terminals 1 and 2 under the above conditions.
If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL" and perform step 3 again.