nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Intake Manifold|Specifications|Page 3197 > < Intake Manifold|Specifications|Page 3195
Page 5
background image

3. Align center to insert quick connector straight into fuel tube.

^

Insert fuel tube into quick connector until the top spool on fuel tubes is inserted completely and the second level spool is positioned slightly
below the quick connector bottom end.

CAUTION:  Hold A position in illustration when inserting fuel tube into quick connector.
^

Carefully align center to avoid inclined insertion to prevent damage to O-ring inside quick connector. 

^

Insert until you hear a "click" sound and actually feel the engagement.

^

To avoid misidentification of engagement with a similar sound, be sure to perform the next step.

4. Before clamping fuel hose with hose clamp, pull quick connector hard by hand holding at the "A" position, as shown. Make sure it is completely

engaged (connected) so that it does not come off of the fuel tube.

NOTE:  Recommended pulling force is 50 N (5.1 kg, 11.2 lb).

5. Install quick connector cap on quick connector joint.

^

Direct arrow mark on quick connector cap to upper side (fuel hose side).

6. Install fuel hose to hose clamp.

Connecting the Quick Connector for the Fuel Hose (Vehicle Piping Side) 
Install the fuel tube quick connector (vehicle piping side side) as follows.
7. Make sure no foreign substances are deposited in and around tube and quick connector and there is no damage on them.
8. Thinly apply new engine oil around the fuel tube tip end.

9. Align center to insert quick connector straight into fuel tube.

^

Insert fuel tube into quick connector until the top spool on fuel tubes is inserted completely and the paint mark is positioned slightly below the
quick connector bottom end.

CAUTION:  
^

Hold A position in illustration when inserting fuel tube into quick connector.

^

Carefully align center to avoid inclined insertion to prevent damage to O-ring inside quick connector.

^

Insert until you hear a "click" sound and actually feel the engagement.

^

To avoid misidentification of engagement with a similar sound, be sure to perform the next step.

Intake Manifold|Specifications|Page 3197 > < Intake Manifold|Specifications|Page 3195