Altima 2.5 SL L4-2.5L (QR25DE) (2002)
/Page-793037.png)
48.
Re-install the alternator.
49.
This Step For Altima ONLY: Re-install the Relay Box.
50.
Re-install the plastic engine cover (as applicable).
51.
Re-connect the negative battery cable.
52.
Re-program all radio station presets.
53.
Return to the Repair Flow Chart for further instructions.
Procedure F - Cut Front Exhaust Pipe Hanger Pin (Altima Only)
Procedure F - Cut Front Exhaust Pipe Hanger Pin (Altima ONLY):
(For PNC code R3007)
1.
Locate the Front Exhaust Pipe Hanger Pin (for the front exhaust pipe). You'll see it on the left side of the exhaust pipe, near the flex joint.
2.
Mark a cut line on the Hanger Pin 30 mm from the forward end (front) of the pin (see Figure F1).
NOTE:
If it looks like the pin has already been trimmed skip step 3 here and move on to the next appropriate step in the Repair Flow Chart.
WARNING:
Wear appropriate eye protection and gloves before performing the next step.
3.
Use a 3" (or equivalent) air-powered cut-off wheel to cut the pin as shown in Figure F1 below.
4.
Return to the Repair Flow Chart for further instructions.
Procedure G - Install Keen-Sert(S) As Needed
Procedure G - Install "Keen-Sert(s)" As Needed
Drill Out Broken Screw(s):
