Altima 2.5 SL L4-2.5L (QR25DE) (2002)
16.
Roll down the driver's window part way, exit the vehicle, close the door, and hang the CONSULT II unit on the outside of the window (see Figure
12).
^
This step is necessary to ensure the CONSULT-II and DLC-II cable will not be disturbed during reprogramming.
CAUTION:
DO NOT connect the CONSULT-II AC power supply for Steps 17, 18 and 19.
Section 2: Confirm the vehicle's battery voltage and CONSULT-II "Charger Input"
17.
Press [SUB MODE] (see Figure 11) then:
A.
Press [DOWN] 4 times.
B.
Select [BATTERY CHARGE].
18.
Check the CONSULT-II's "Charger Input "reading (see Figure 13).
NOTE:
^
"Battery Voltage" is the voltage level of CONSULT-II's battery.
^
"Charger Input" is the voltage level of the vehicle's battery. (It must be above 12 volts).
19.
The "Charger Input" reading MUST be above 12 volts (see Figure 13).
^
A reading above 12 volts confirms
a.
The DLC-II is properly connected to the vehicle,
b.
The vehicle battery voltage is sufficient for ECM reprogramming, and