Altima 2.5 SL L4-2.5L (QR25DE) (2002)
/Page-2276008.png)
12.
Apply the piece of tape (supplied in the kit) over the Connector Clips (see Figure 13). This will prevent the edges of the Connector Clips from
damaging other wires.
Re-assembly:
13.
Re-install the Air Bag Module to the Steering Wheel using the new screws supplied in the kit (see Figure 9). Tighten the pew screws to: 71 - 115
in-lb.
14.
Re-install the Audio Control and Automatic Speed Control to the steering wheel with the four screws (see Figure 8).
15.
Re-install the Audio Control and Automatic Speed Control Covers, making sure the grooves in the covers align with the Guide Ribs on the
controls (see Figure 14).
Check Air Bag Module Warning Light (on Instrument Panel):
CAUTION:
Make sure the ignition key is in the OFF position and all doors are closed before reconnecting the battery cables (next step)
16.
Re-connect both battery cables.
17.
From the passenger side, turn the ignition key to the ON position.
a.
If the Air Bag Module Warning Light turns OFF after 5 - 7 seconds, proceed to "Final Steps".
b.
If the Air Bag Module Warning Light does NOT turn ON at first, does NOT turn OFF. or blinks, refer to the applicable Service Manual for
diagnosis/repair Then proceed to "Final Steps".
Final Steps:
