Altima 2.5 SL L4-2.5L (QR25DE) (2002)
Windshield: Service and Repair
WINDSHIELD GLASS
Removal and Installation
REMOVAL
1. Remove the front pillar garnish. Refer to "BODY SIDE TRIM".
2. Partially remove the headlining (front edge). Refer to "HEADLINING".
3. Remove the front wiper arms. Refer to "Removal and Installation for Front Wiper Arms, Adjustment for Wiper Arms Stop Location". See: Wiper
and Washer Systems/Wiper Arm/Service and Repair
4. Remove drip molding. Refer to "DRIP MOLDING".
5. Apply a protective tape around the windshield glass to protect the painted surface from damage.
After removing moldings, remove glass using piano wire or power cutting tool and an inflatable pump bag.
-
If a windshield glass is to be reused, mark the body and the glass with mating marks.
WARNING: When cutting the glass from the vehicle, always wear safety glasses and heavy gloves to help prevent glass splinters from entering
your eyes or cutting your hands.
CAUTION: When a windshield glass is to be reused, do not use a cutting knife or power cutting tool.
NOTE:
-
Be careful not to scratch the glass when removing.
-
Do not set or stand the glass on its edge. Small chips may develop into cracks.
INSTALLATION
-
Use a genuine Nissan Urethane Adhesive Kit or equivalent and follow the instructions furnished with it.
-
While the urethane adhesive is curing, open a door window. This will prevent the glass from being forced out by passenger compartment air
pressure when a door is closed.
-
The molding must be installed securely so that it is in position and leaves no gap.
-
Inform the customer that the vehicle should remain stationary until the urethane adhesive has completely cured (preferably 24 hours). Curing time
varies with temperature and humidity.