Armada 2WD V8-5.6L (VK56DE) (2006)
VERY IMPORTANT:
^
Make sure the DLC-II is pushed in straight and fully plugged in to the vehicle connector.
^
Make sure all other DLC-II cable connections (as shown in Figure 11) are connected properly.
CAUTION
^
Nissan requires the use of essential tools shown in Figure 11 when performing ABS/VDC reprogramming.
^
J44200-1O "Pigtail" should not be removed from the CONSULT-II DDL Port. This "Pigtail" allows use of the stronger "quick disconnect" cable
set.
^
If cables are very often changed at the DDL Port (base) of the CONSULT-II unit, cable connector pin damage may result.
^
If there is connector pin damage, ABS/VDC reprogramming may fail. Permanent damage to the ABS/VDC system can occur.
4.
Continue with Section 2
Section 2
Section 2: Check all Systems in "SELF-DIAG RESULTS" and erase any DTCs.
CAUTION:
It is essential that you check all Systems in "SELF-DIAG RESULTS" and erase any DTCs before performing the remaining sections of this
procedure.
1.
Remove the 8 MB orange card from CONSULT-II.
2.
Install the 16 MB (red/white) Diagnostic Card into Slot A (top slot) of CONSULT-II (see Figure 12).
3.
Press [START (Nissan BASED VHCL)]
4.
In "SELF-DIAG RESULTS", check and erase any DTCs that are stored in the following vehicle systems:
^
ENGINE
^
A/T
^
ABS
^
AIRBAG
^
ALL MODE AWD/4WD (if applicable)
^
DIFF LOCK (if applicable; 4WD Titan)
^
AIR LEVELIZER (if applicable)