Armada 2WD V8-5.6L (VK56DE) (2006)
Disclaimer
Service Procedure
SERVICE PROCEDURE
1.
Start the engine and confirm:
^
if a squeak noise is coming from the drive belt
and
^
using a stethoscope or similar tool, if the drive belt auto tensioner is making abnormal noise.
2.
Turn the engine off.
3.
Write down the radio presets for later reprogramming.
4.
Remove intake duct and engine cover.
5.
Disconnect battery, negative cable first, and wait at least 3 minutes before proceeding to step 6.
6.
Remove drive belt and drive belt auto tensioner. Refer to section EM of the Electronic Service Manual for removal procedure.
7.
Lift up vehicle by placing it on a hoist.
8.
Remove front right wheel.
9.
Remove fender protector. Refer to section EXT of the ESM for removal procedure.
10.
Remove engine under cover (6 bolts).
11.
Check the pulley alignment as follows: