nissan Workshop Repair Guides

Nissan and Datsun Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 11931 > < Diagram Information and Instructions|Page 11929
Page 2
background image

c. Remove the fuel filler pipe shield.

d. Disconnect the fuel filler hose from the fuel filler pipe.
e. Insert a suitable hose into the fuel tank through the fuel filler hose to drain the fuel from the fuel tank.

-

As a guide, the fuel level reaches the fuel gauge position as shown, or less, when approximately 14 liters (3 3/4 US gal, 3 1/8 Imp gal) of
fuel are drained from the fuel tank.

3. Release the fuel pressure from the fuel lines. Refer to "FUEL PRESSURE RELEASE".
4. Disconnect the battery negative terminal.
5. Remove the second row LH rear seat and the third row rear seat. Refer to "THIRD SEAT".
6. Remove the second and third row rear seat belt buckles mounted on the floor. Refer to "SEAT BELTS".
7. Remove the LH center pillar trim, the LH rear trim panel, and the LH rear side door kick plate and weather stripping. Refer to "BODY SIDE

TRIM".

8. Remove the second row rear center console and base, if equipped. Refer to "FLOOR TRIM".
9. Reposition the floor carpet out of the way to access the inspection hole cover, located under the center LH rear seat.

10. Remove the inspection hole cover by turning the retainers  90 degrees clockwise.

-

Remove the O-ring.

Diagram Information and Instructions|Page 11931 > < Diagram Information and Instructions|Page 11929