Armada 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Impact Sensor: Service and Repair
Removal And Installation
CRASH ZONE SENSOR
Removal and Installation
REMOVAL
CAUTION:
-
Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
-
Replace crash zone sensor if it has been dropped or sustained an impact.
-
Do not disassemble crash zone sensor.
1. Disconnect the negative and positive battery cables, then wait at least 3 minutes.
2. Remove front grille. Refer to See: Body and Frame/Grille/Service and Repair.
3. Disconnect the crash zone sensor harness connector.
4. Remove crash zone sensor nuts.
INSTALLATION
Installation is in the reverse order of removal.
-
After the work is complete, perform self-diagnosis to check that no malfunction is detected. Refer to See: Air Bag Systems/Testing and
Inspection/Component Tests and General Diagnostics/On Board Diagnostic (OBD) System.