Armada 2WD V8-5.6L (VK56DE) Flex Fuel (2009)
Wiper Motor Linkage: Service and Repair
FRONT WIPER DRIVE ASSEMBLY
Wiper Motor and Linkage
REMOVAL AND INSTALLATION
Removal
1. Remove the cowl top. Refer to See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair.
2. Remove wiper frame bolts and remove wiper frame assembly.
3. Remove wiper motor from wiper frame assembly.
Installation
CAUTION:
-
Do not drop the wiper motor or cause it to contact other parts.
-
Check the grease conditions of the motor arm and wiper link joint(s). Apply grease if necessary.
1. Connect wiper motor to connector. Turn the wiper switch ON to operate wiper motor, then turn the wiper switch OFF (auto stop).
2. Disconnect wiper motor connector.
3. Install wiper motor to wiper frame assembly, and install wiper frame assembly.
4. Install cowl top. Refer to See: Body and Frame/Cowl/Cowl Moulding / Trim/Service and Repair.
5. Ensure that wiper blades stop within proper clearance. Refer to front wiper arm adjustment See: Wiper Arm/Service and Repair/Front Wiper Arm.