Armada 4WD V8-5.6L (VK56DE) Flex Fuel (2009)
3. Install brake tube to brake hose, then tighten the flare nut using a suitable tool. Refer to See: Diagrams.
4. Refill brake fluid and bleed air. Refer to See: Brake Bleeding/Service and Repair.
Rear Brake Piping And Brake Hose
BRAKE TUBE AND HOSE
Removal and Installation of Rear Brake Piping and Brake Hose
REMOVAL
1. Drain brake fluid. Refer to See: Brake Fluid/Service and Repair/Removal and Replacement.
2. Remove brake tube from brake hose, using a suitable tool.
3. Remove lock plate and brake hose from bracket.
4. Remove union bolt and then remove brake hose from cylinder body.
INSTALLATION
1. Install brake hose by aligning with the protrusion on cylinder body, then install the union bolt and new copper washers and tighten to specification.
Refer to See: Diagrams.