Armada 4WD V8-5.6L (VK56DE) Flex Fuel (2009)
10. Remove the inspection hole cover by turning the retainers 90° degrees clockwise.
-
Remove the O-ring.
11. Disconnect the fuel level sensor, fuel filter, and fuel pump assembly electrical connector, the EVAP hose, and the fuel feed hose.
Disconnect the quick connector as follows:
-
Hold the sides of the connector, push in tabs and pull out the tube.
-
If the connector and the tube are stuck together, push and pull several times until they start to move. Then disconnect them by pulling.
CAUTION:
-
The quick connector can be disconnected when the tabs are completely depressed. Do not twist the quick connector more than necessary.
-
Do not use any tools to disconnect the quick connector.
-
Keep the resin tube away from heat. Be especially careful when welding near the tube.
-
Prevent any acid liquids such as battery electrolyte, from getting on the resin tube.
-
Do not bend or twist the resin tube during connection.
-
Do not remove the remaining retainer on the hard tube (or the equivalent) except when the resin tube or the retainer is replaced.