Armada 4WD V8-5.6L (VK56DE) Flex Fuel (2009)
1. Disconnect both battery cables. then wait at least 3 minutes.
2. Remove the center pillar upper/lower finishers. Refer to See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair.
3. Remove the retractor anchor bolt, retractor bolt upper, then remove the retractor and belt assembly.
-
On RH side, disconnect the seat belt tension sensor.
4. Disconnect the seat belt pre-tensioner electrical connector.
CAUTION:
-
For removing pre-tensioner connector, insert a thin screwdriver (1) wrapped in tape (3) into the notch. Lift the locking tab to unlock (2),
then remove the connector.
-
Install the pre-tensioner connector with the locking tab raised, then push the locking tab into the connector to lock (4).
Installation
Installation is in the reverse order of removal.
-
Install the seat belt retractor and belt assembly bolt upper first.
-
Make sure that seat belt height adjuster is locked in the lowest position during installation.
FRONT SEAT BELT BUCKLE
Removal
1. Remove the front seat. Refer to See: Body and Frame/Seats/Service and Repair/Front Seat/Removal and Installation.
2. Remove the seat cushion. Refer to See: Body and Frame/Seats/Service and Repair/Front Seat/Disassembly and Assembly.