Axxess 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1990)
Refer to Section SB in the Warranty Flat Rate Manual.
Technical Service Bulletin # BF89018
Date: 891116
Interior Trim - Loose A-Pillar Garnish Moldings
Classitication:
Section:
BF89-018
Body & Frame
Reference:
TECHNICAL BULLETIN
TS89-119
Models:
1990 Axxess (M11)
Date:
November 16, 1989
LOOSE INTERIOR A-PILLAR FINISHER
APPLIED MODEL: 1990 Axxess
SERVICE INFORMATION
FIGURE 1
The A-pillar garnish moldings on some 1990 Axxess vehicles may be loose at the upper rear portion of the molding. This is caused by a slight
misalignment between the molding clips and the clip mounting holes (Figure 1). If an A-pillar garnish molding is found to be loose, repair according to
the following procedure.
FIGURE 2
SERVICE PROCEDURE
1.
Carefully remove the loose A-pillar garnish molding.
2.
Remove the second clip (Figure 2, # 2) from the garnish molding. After removing the garnish, cut away the second clip bracket from the A-pillar
garnish molding.