Cube L4-1.8L (MR18DE) (2010)
d. Hold the WAF part of oil pump shaft [WAF: 10 mm (0.39 in)] (A), and then loosen the oil pump sprocket bolt and remove it.
CAUTION:
-
Secure the oil pump shaft with the WAF part.
-
Never loosen the oil pump sprocket bolt by tightening the oil pump drive chain.
e. Remove crankshaft sprocket, oil pump sprocket, and oil pump drive chain as a set.
15. Remove tension guide (front cover side) from front cover, if necessary.
INSTALLATION
NOTE:
The figure shows the relationship between the matching mark on each timing chain and that on the corresponding sprocket, with the components
installed.