Cube L4-1.8L (MR18DE) (2010)
4. Hold the WAF part of oil pump (2) shaft [WAF: 10 mm (0.39 in)] (A), and then tighten the oil pump shaft sprocket bolt.
CAUTION:
-
Secure the oil pump shaft with the WAF part.
-
Never loosen the oil pump shaft sprocket bolt by tightening the oil pump drive chain.
5. Install oil pump chain tensioner (1).
-
Fix the plunger at the most compressed position using a stopper pin (A), and then install it.
-
Securely pull out ( Black Arrow) the stopper pin after installing the oil pump chain tensioner.
-
Check matching mark position of oil pump drive chain and each sprockets again.
6. Align the matching marks of each sprockets with the matching marks of timing chain.