Cube L4-1.8L (MR18DE) (2010)
Cabin Temperature Sensor / Switch: Service and Repair
Removal And Installation
INTAKE SENSOR
Removal and Installation
REMOVAL
1. Remove the evaporator assembly. See: Housing Assembly HVAC/Service and Repair/Automatic Air Conditioner.
2. Remove the intake sensor from evaporator.
INSTALLATION
Installation is basically the reverse order of removal.
CAUTION:
-
Replace O-rings with new ones. Then apply the compressor oil to them when installing.
-
Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position.
-
Never rotate the bracket insertion part when removing and installing the intake sensor.
-
Check for leakages when recharging refrigerant. See: Refrigerant/Service and Repair/Leak Test.