Cube L4-1.8L (MR18DE) (2010)
Is the inspection result normal?
YES - GO TO 3.
NO - Repair harness or connector.
3.CHECK SEAT BELT BUCKLE SWITCH (DRIVER SIDE) GROUND CIRCUIT
Check harness continuity between seat belt buckle switch (driver side) harness connector and ground.
Is the inspection result normal?
YES - INSPECTION END
NO - Repair harness or connector.
Component Inspection
SEAT BELT BUCKLE SWITCH SIGNAL CIRCUIT
Component Inspection
1.CHECK SEAT BELT BUCKLE SWITCH (DRIVER SIDE)
1. Turn ignition switch OFF.
2. Disconnect the seat belt buckle switch (driver side) connector.
3. Check continuity between terminals.
Is the inspection result normal?
YES - INSPECTION END
NO - Replace seat belt buckle (driver side). See: Restraint Systems/Seat Belt Systems/Seat Belt Buckle/Service and Repair/Front Seat Belt/Removal
And Installation.