Nissan and Datsun Workshop Service and Repair Manuals

Accelerator Pedal: Procedures

ACCELERATOR CONTROL SYSTEM

Inspection

INSPECTION AFTER INSTALLATION
-

Check accelerator pedal moves smoothly within the whole operation range when it is fully depressed and released.

-

Check accelerator pedal securely returns to the fully released position.

-

For the electrical inspection of accelerator pedal position sensor. See: Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/P Code Charts/P2122.

- CAUTION:
When harness connector of accelerator pedal position sensor is disconnected, perform "ACCELERATOR PEDAL RELEASED POSITION
LEARNING".  See: Testing and Inspection/Programming and Relearning/Accelerator Pedal Released Position Learning/Description See:
Testing and Inspection/Programming and Relearning/Accelerator Pedal Released Position Learning/Special Repair Requirement See:
Computers and Control Systems/Testing and Inspection/Programming and Relearning/Throttle Valve Closed Position Learning/Description 
See: Computers and Control Systems/Testing and Inspection/Programming and Relearning/Throttle Valve Closed Position Learning/Special
Repair Requirement See: Testing and Inspection/Programming and Relearning/Idle Air Volume Learning/Description See: Testing and
Inspection/Programming and Relearning/Idle Air Volume Learning/Special Repair Requirement