Cube L4-1.8L (MR18DE) (2010)
Transmission Speed Sensor: Service and Repair
Primary Speed Sensor
Exploded View
PRIMARY SPEED SENSOR
Exploded View
Removal And Installation
PRIMARY SPEED SENSOR
Removal and Installation
REMOVAL
1. Remove battery. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement/Exploded View.
2. Remove air duct (inlet), air duct and air cleaner case. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air
Cleaner Housing/Service and Repair/Exploded View.
3. Remove battery bracket.
4. Remove control cable from manual lever. See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Shift Linkage/Service
and Repair/Exploded View.
5. Place manual lever to "L" position.
6. Disconnect primary speed sensor connector.
7. Remove primary speed sensor.
8. Remove O-ring from primary speed sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
-
Never reuse O-ring.
-
Apply CVT fluid to O-ring.
Inspection
PRIMARY SPEED SENSOR
Inspection
INSPECTION AFTER INSTALLATION