Cube L4-1.8L (MR18DE) (2010)
/Page-745009.png)
21. Install the manual valve (see Figure 12).
22. Install the manual plate while aligning it with the notch in the manual valve, and then install the lock washer and nut (see Figure 12).
CAUTION:
Hold the manual shaft with a 6 mm open end wrench while the nut is being torqued.
* Do not confuse in-lbs with ft lbs.
23. Install the black CVI connector in its transmission case mounting hole.
^
Secure it by installing its large lock ring.
^
Secure the gray CVI connector to the black CVI connector.
24. Install the oil pan with a new gasket.
^
Make sure the oil pan and magnets are clean.
25. Install the undercover.
26. Connect both battery cables, negative cable last.
27. Check the fluid level.
^
Add as necessary.
^
Inspect for fluid leaks.
28. Perform 1CM initialization.
^
Refer to TCM Initialization Procedure.
29
Reset / initialize all applied systems i.e., radio, power windows, clock, sunroof, etc.
^
Refer to the ESM as needed.
30. Using C-III, make sure to erase DTCs from all Systems.
