Cube L4-1.8L (MR18DE) (2010)
3. Remove the CVT oil warmer from the old CVT assembly, and install it on the new CVT assembly (see Figure 3).
4. Remove the radiator assembly.
^ Refer to the appropriate section of the ESM, if needed.
5. Install the new radiator (with CVT cooler) assembly.
^ Refer to the appropriate section of the ESM, if needed.
6. Install the new CVT assembly.
^ Refer to the appropriate section of the ESM, if needed.
7. Fill / adjust CVT fluid and coolant levels as necessary.
^ Refer to the appropriate section of the ESM, if needed.
8. Reprogram the radio presets.
9. Reset / initialize all applied systems i.e., power windows, clock, sunroof, etc.
^ Refer to the ESM as needed.
TCM Initialization Procedure
1. Set the parking brake with the selector lever in "P" (Park).
2. C-III and the Vehicle Interface (VI) should still be on and connected, and the vehicle ignition turned ON (engine OFF - not running).
3. Navigate C-III screens to Transmission, then Special Functions.
4. Select the TCM part number (P/N) and Calibration Data, and then print and save a copy.
5. Perform the initialization (EEPROM erase) procedure as follows:
a. Select Transmission Self Diagnostic Results.
b. Shift the selector lever to "R" (Reverse).
c. Press and hold the brake pedal.
d. Press and hold the accelerator pedal down about one-third, but no more than halfway. The purpose of this step is to get both the wide open throttle
and closed throttle position signals to read "OFF" at the same time.