D21 Hardbody 2WD L4-2389cc 2.4L SOHC MFI (KA24E) (1990)
fine emery paper - be careful not to score surface).
3.
Apply a coating of grease to the heater "O" ring and machined surface of the Engine Block Hole (To facilitate installation and prevent "O"
ring damage).
DO NOT USE GASKET GLUE - Gasket glue hardens preventing proper seal and eventually cause leaks.
4.
Refer to element direction shown in chart. Insert heater with element pointing in proper direction and push flush to block.
5.
Tighten screw to 14-19 inch pounds torque maximum.
6.
Install the power cord and route it to the grille, taping it and securing it with plastic tie wraps where necessary to insure that the cord does not
touch any hot pipes, engine components or moving pans.
7.
Refill cooling system, pressurize to radiator cap relief pressure and check for leaks. Operate engine to check further for leaks. Refer to
manufacture's recommended procedures.
Note:
It is recommended that low phosphate anti-freeze be used, and that a maximum anti-freeze/ water mixture ratio of 50/50 be used.
Refer to the Nissan Owner's Manual, Engine Cooling System section.
8.
Use cable end protector cap when heater is not plugged into power source.
WARNING:
Before connecting heater to power source, make sure that cooling system is full with recommended coolant
Engine Lower Hose Heater
200SX (CA18ET, CA20E Engines)
-
1984 to 1988
Stanza (Sedan)
-
1987 to 1988
Truck (VG30 Engine)
-
1986.5 and Later
Pathfinder (VG30 Engine)
-
1987 and Later
Truck (KA24E Engins, 4WD only)
-
1990 and Later
Part Number:
99998-1024701
INSTALLATION INSTRUCTIONS
Parts List
Item
No.
Qty.
Item
1
(1)
Lower Radiator Hose
Heater (with power cord and plug cap)
2
(2)
Hose Clamp
Tools Required
Phillips Srewdriver Flat Blade Screwdriver Heavy Duty Utility Knife Masking Tape or Chalk Electrical Tape or Wire Tie (Plastic or Wire) Measuring
Tape or Ruler