D21 Hardbody 2WD L4-2389cc 2.4L SOHC MFI (KA24E) (1990)
1.
Remove air cleaner assembly and detach engine harness from engine (section between valve cover and throttle body). (Figure 2)
2.
Remove the harness covering (plastic shield/electrical tape) and locate the splice connection. A single ground wire (B/G) is connected to three
other wires (also, B/G) with a pressed metal connector.
To ensure a positive connection at this splice, solder the metal connector to the wires to form a permanent connection (Figure 3).
3.
Wrap soldered splice with heat shrink tape to ensure a waterproof seal. Reinstall plastic shield and wrap with 3M Electrical Tape (3M P/N 88) or
equivalent.
4.
Reattach harness to engine and replace air cleaner assembly.
5.
Test drive vehicle to ensure that incident is resolved.
WARRANTY INFORMATION