D21 Hardbody 2WD L4-2389cc 2.4L SOHC MFI (KA24E) (1990)
/Page-890001.png)
Fuel Injector: Testing and Inspection
Component Testing Procedures
Fig. 140 Injector Inspection
1.
Remove the injector connector.
2.
Using an ohm meter, check its resistance.
Resistance should be approximately 12 ohms.
If OK, proceed to step #3.
If not OK, replace the injector.
3.
Remove the injector (refer to COMPONENT REPAIR AND REPLACEMENT PROCEDURES) and check nozzle for restriction.
Replace the injector if it fails the above test.
