D21 Hardbody 4WD V6-2960cc 3.0L SOHC MFI (VG30E) (1991)
Note:
The first point of resistance is the bolt threads starting to cut into the plastic just past the metal insert inside the ECM. You must continue turning the
bolt to completely seat the bolt and connector.
3.
Torque the bolt to approximately 45 in.lbs. (4.9 N-m or .5Kgm or 3.6 ft.lbs.). When the connector is torqued and fully seated, the orange pin on
the harness connector will come out as shown above.
Caution:
Do not exceed 40-50 in.lbs. of torque on this bolt. If the head breaks off, the connector cannot be removed from the ECM.