D21 Hardbody 4WD V6-2960cc 3.0L SOHC MFI (VG30E) (1991)
9. Remove grease seal in bearing cage with suitable bar.
10. Remove wheel bearing outer race with a brass drift.
INSPECTION
Axle Shaft
-
Check axle shaft for straightness, cracks, damage, wear and distortion. Replace if necessary.
Wheel Bearing
-
Make sure wheel bearing rolls freely and is free from noise, cracks, pitting and wear.
Axle Case
-
Check axle case for yield, deformation and cracks. Replace if necessary.
INSTALLATION
1. Install wheel bearing outer race with a brass drift.
2. Install a new grease seal in bearing cage.
NOTE: After installing new grease seal, coat sealing lip with multipurpose grease.
3. Install bearing spacer with chamfer side facing axle shaft flange.
4. Install wheel bearing inner race with a brass drift.
5. Coat each bearing cone with multi-purpose grease.