D21 Hardbody 4WD V6-2960cc 3.0L SOHC MFI (VG30E) (1991)
7. Separate drive shaft from knuckle by slightly tapping it.
Installation
Installation is the reverse of removal, noting the following:
Apply multi-purpose grease as shown
Install bearing spacer onto drive shaft.
Note:Make sure that bearing spacer Is facing in proper direction.
When installing drive shaft, adjust drive shaft axial end play by selecting a suitable snap ring.
1. Temporarily install new snap ring on drive shaft in the same thickness as it was installed before removal.
2. Set dial gauge on drive shaft end.