D21 Hardbody SE King Cab 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1997)
/Page-2140004.png)
Air Bag Module And Spiral Cable - Installation
3. Rotate the spiral cable fully clockwise until tight.
4. Rotate spiral cable counterclockwise as specified below. Align the white pin with the alignment mark.
Air Bag Module And Spiral Cable - Installation
Specified Turns For Spiral Cable
CAUTION: The spiral cable may snap during steering operation if the cable is installed improperly. Also, with the steering linkage disconnected, the
cable may snap by turning the steering wheel beyond the specified number of turns. Always perform SRS self-diagnosis after installing the air bag
module.
5. Connect spiral cable air bag harness and main harness connectors and tighten screws. Install steering column cover.
Air Bag Module And Spiral Cable - Installation
6. Install mass damper on steering wheel.
7. Install steering wheel, setting spiral cable pin guide, and pulling spiral cable harness through.
8. Connect horn connector.
9. Tighten steering wheel nut.
29 - 39 N-m (3.0 - 4.0 kg-m, 22 - 29 ft-lb)
