D21 Hardbody SE King Cab 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1997)
/Page-2140005.png)
Air Bag Module And Spiral Cable - Installation
10. Position air bag module and tighten with new special bolts.
11. Connect air bag module connector.
12. Install ASCII switch and tighten screws.
13. Install all lids.
14. Connect both battery cables.
15. Conduct Self-diagnosis to ensure entire SRS operates properly (Use CONSULT or warning lamp check). Turn steering wheel to the left end and
then to the right end fully to make sure that the spiral cable is set in the neutral position.
16. If 'AIR BAG" warning lamp blinks (in User mode), it shows that the spiral cable may be snapped due to its improper position. Perform
Self-diagnosis again (Use CONSULT or warning lamp check). If a malfunction is detected, replace the spiral cable with a new one.
