D21 Hardbody SE King Cab 4WD L4-2389cc 2.4L SOHC MFI (KA24E) (1997)
3. Install piston by rotating it slowly and evenly.
-
Apply ATF to inner surface of transmission case.
4. Install return springs, spring retainer and low one-way clutch inner race onto transmission case.
5. Install dish plate, low & reverse brake drive plates, driven plates and retaining plate.
6. Install snap ring on transmission case.
7. Check operation of low & reverse brake clutch piston.
8. Measure clearance between retaining plate and snap ring. If not within allowable limit, select proper retaining plate
Specified clearance:
Standard: 0.8 - 1.1 mm (0.031 - 0.043 inch)
Allowable limit: 2.3 mm (0.091 inch)
Part Number and thickness of retaining plate:
31667-41x12: 7.0 mm (0.276 inch)
31667-41x13: 7.2 mm (0.283 inch)
31667-41x14: 7.4 mm (0.291 inch)
31667-41x07; 7.6 mm (0.299 inch)