Frontier 2WD L4-2.5L (QR25DE) (2005)
Make sure:
^ Sender connector and fuel pump connector are securely connected.
^ Fuel pump harness and sender harness are wrapped / twisted together.
^ Sender and temp sensor wires are inside guide clip.
^ Sender unit is locked in place.
^ Temp sensor is clipped in place.
CAUTION:
Do not bend the float arm when handling the new fuel gauge sender unit.
6. Install the sender unit cover over the sender unit.
^ Slide cover on until it snaps in place.
^ Make sure the 2 clips at the top of the cover are snapped / locked in place.
^ Make sure the lower flange is under the bottom of the fuel pump assembly.
^ Carefully move the float arm through its entire range of motion making sure there is no interference.