Frontier 2WD V6-3.3L (VG33E) (2003)
Electronic Brake Control Module: Service and Repair
ABS/VDC/TCS
ABS Actuator and Electric Unit
ABS/VDC/TCS ACTUATOR AND ELECTRIC UNIT
REMOVAL
1. Disconnect battery cable.
2. Disconnect connector and brake pipes.
3. Remove fixing bolts.
INSTALLATION
CAUTION: After installation, refill brake fluid. Then bleed air.
1. Connect brake pipes temporarily.
2. Tighten fixing bolts.
3. Tighten brake pipes.
Tightening torque:.........................16.7 - 21.6 Nm (1.7 - 2.2 kgf-cm, 13 -15 ft. lbs.)
4. Connect connector and battery cable.
5. Adjust steering angle sensor neutral position.
See: Steering Angle Sensor