Frontier 2WD V6-3.3L (VG33E) (2003)
/Page-452003.png)
^
Throttle position sensor
^
Throttle position switch
^
Distributor (ignition coil)
^
Distributor
^
EGRC solenoid valve (VG33E only)
^
EGR temperature sensor (VG33E only)
b. Water hoses from collector
c. Heater hoses
d. PCV hose from RH/LH rocker cover
e. Vacuum hoses for:
^
Brake master cylinder
^
Pressure regulator
f.
Purge hose from purge control valve
g. Spark plug wires
h. Distributor assembly
i.
Three left/right bank injector connectors
j.
Ground harness
7. Remove the fuel feed and fuel return hoses from the injector fuel tube assembly.
8. Disconnect the right injector harness connectors
9. Remove the injector fuel tube assembly.
10. Remove the intake manifold from the engine, loosen the bolts in numerical order as shown. The following parts should be disconnected to remove
intake manifold:
^
Engine coolant temperature switch harness connector
^
Thermal transmitter harness connector
^
Water hose from the thermostat housing
11. Remove both of the camshaft sprockets.
12. Remove the rear timing belt cover.
13. Remove the distributor and ignition wires.
