Frontier 2WD V6-3.3L (VG33E) (2003)
Air Bag Deactivation Switch: Service and Repair
Passenger Air Bag Deactivation Switch Lock Cylinder
Passenger Air Bag Deactivation Switch Lock Cylinder
Removal
Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait for at least 3 minutes.
1. Remove cluster lid C.
Refer to Instrument Panel, "Removal and Installation".
See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster / Carrier
2. Disengage the two locking tabs from the passenger air bag deactivation switch lock cylinder and remove the passenger air bag deactivation switch.
3. Remove two retaining screws from the cluster lid C and remove the passenger air bag deactivation switch lock cylinder.
Installation
NOTE:
Be sure that the passenger air bag deactivation switch and lock cylinder is connected and in the same position as during removal for proper
engagement.
To install, reverse removal procedure.
After replacement, perform self-diagnosis for SRS. Refer to "SRS Operation Check". See: Air Bag Systems/Testing and
Inspection/Component Tests and General Diagnostics