Frontier 2WD V6-3.3L (VG33E) (2003)
Torsion Bar: Service and Repair
TORSION BAR SPRING / Removal
1. Move dust cover.
2. Paint matching marks on the torsion bar spring and the corresponding arm.
NOTE: Always use paint to place the matching mark; do not scribe the affected parts.
3. Measure anchor bolt protrusion "L" and remove the lock nut and adjusting nut.
WARNING: Before removing the nuts, ensure that twisting force is eliminated from the torsion bar springs.
Standard length "L":...............68 mm (2.68 inch)