Frontier SC King Cab 2WD V6-3.3L SC (VG33ER) (2002)
3) Remove connector and flow control valve with spring.
^
Be careful not to drop flow control valve.
Inspection
^
If pulley is cracked or deformed, replace it.
^
If fluid leak is found around the pulley shaft, replace the oil seal.
Assembly
Assemble oil pump, noting the following instructions.
^
Make sure O-rings and oil seal are properly installed.
^
Always install new O-rings and oil seal.
^
Be careful of oil seal direction.
^
Cam ring, rotor and vanes must be replaced as a set if necessary.
^
When assembling, coat each part with Genuine NISSAN PSF II or equivalent.
^
Pay attention to the direction of rotor.
^
When assembling vanes to rotor, rounded surfaces of vanes must face cam ring side.