Frontier XE 4WD L4-2.4L (KA24DE) (1998)
/Page-451005.png)
NOTE:
Make sure the flat side of the distributor drive shaft is facing the engine (see Figure 6). Failure to do so will result in the distributor being out of time.
8.
Install the following parts:
a.
Crankshaft pulley.
b.
A/C compressor and idler pulley bracket.
c.
Radiator shroud and cooling fan with coupling.
d.
A/C compressor, alternator and power steering pump drive belts.
e.
Air duct.
Installation of Upper Timing Chain
1.
Install the lower timing chain (refer to "Installation of Lower Timing Chain" in this bulletin).
2.
Install upper timing chain and sprockets, using the painted reference marks made during removal.
3.
Install chain tensioner. Remove the pin holding the tensioner piston in the bore of the tensioner.
4.
Install camshaft sprocket cover:
a.
Use a scraper to remove all traces of liquid gasket from the mating surfaces of the engine block and camshaft sprocket cover.
b.
Apply a continuous bead of RTV sealant to the cover as shown in Figure 7.
NOTE:
