Frontier XE King Cab 4WD L4-2.4L (KA24DE) (1998)
6. Tighten the adjusting nut so the torsion bar length corresponds with dimension "L", previously measured during torsion bar removal. Tighten the
lock nut to specifications. If a new torsion bar spring or anchor arm is installed, tighten the adjusting nut to the dimension indicated in the figure,
then tighten the lock nut to specifications.
Standard length "L":
(2WD) = 54 mm (2.13 inch)
(4WD) = 70 mm (2.76 inch)
7. Bounce vehicle with tires on ground (Unladen) to eliminate friction of suspension.
8. Measure vehicle posture "H".
a. Exercise the front suspension by bouncing the front of the vehicle 4 or 5 times to ensure that the vehicle is in a neutral height attitude.
b. Measure vehicle posture, i.e. dimension "H"
H = A - B mm (inch) "Unladen"
Refer to Alignment Specification table.
9. If height of the vehicle is not within allowable limit, adjust vehicle posture.
10. Check wheel alignment if necessary.