Frontier XE King Cab 4WD V6-3.3L (VG33E) (2002)
D.
Touch "SET TIME".
^
If time is not correct, touch the hour, minute or AM/PM as needed. Then adjust it by using arrow keys. Once done, press "SAVE", press
"BACK" and go to step 4.
^
If time is OK, press "BACK" and go to step 4.
Set the Ethernet (IP) Address of the ASIST PC and CONSULT-II as follows:
NOTE:
If your ASIST terminal has been used to perform ECM Reprogramming before, you may skip steps "A" through "I" below and proceed to step 5.
If you are unsure whether your ASIST terminal has been already set up for ECM Reprogramming, proceed to step "A" below.
A.
On the ASIST PC, click "START", "SETTINGS", "CONTROL PANEL", and then select "NETWORK".
B.
When the "Network Configuration" screen appears (see Figure 3) select "TCP/IP". Then select "PROPERTIES".
C.
Compare Figure 4 with the "TCP/IP PROPERTIES" screen on the ASIST PC.
^
If the "IP ADDRESS" and "SUBNET MASK" appear EXACTLY as shown in Figure 4, click "CANCEL" and close the "CONTROL
PANEL" box. Now continue to step "D".
^
If the "IP ADDRESS" and "SUBNET MASK" do not match EXACTLY as shown in Figure 4, change the numbers so that they do.
Click "OK", reboot the computer to save the new IP Address, and continue to step "D".
D.
On CONSULT-II Touch "CONFIGURE ETHERNET".