Nissan and Datsun Workshop Service and Repair Manuals > Maxima V6-2960cc 3.0L DOHC (VE30DE) (1992) > Engine, Cooling and Exhaust | Engine | Timing Components | Timing Chain | Component Information | Technical Service Bulletins | Engine - Cam Timing Procedure Supplement

Timing Chain|Service and Repair > < Engine - Cam Timing Procedure Supplement|Page 1681

Page 5

If the tensioners were removed, install them at this time (Figure 12)

With the spark plugs removed, rotate the engine, by hand, four revolutions clockwise and set it to Top Dead Center (TDC), compression, # 1
cylinder. Be sure the engine turns freely. If it does not turn freely, stop immediately and recheck assembly procedures.

Verify that the intake and exhaust cam match marks align with the cam cap arrows on both cylinder heads.

10.

The cams are now "in time." Continue with engine assembly.

Engine, Cooling and Exhaust
Engine
Timing Components
Timing Chain / Technical Service Bulletins / Engine - Cam Timing Procedure Supplement
Page 1682

Timing Chain|Service and Repair > < Engine - Cam Timing Procedure Supplement|Page 1681

Nissan and Datsun Workshop Service and Repair Manuals

Maxima V6-2960cc 3.0L DOHC (VE30DE) (1992)

Engine, Cooling and Exhaust Engine Timing Components Timing Chain / Technical Service Bulletins / Engine - Cam Timing Procedure Supplement Page 1682

Engine, Cooling and Exhaust Engine Timing Components Timing Chain / Technical Service Bulletins / Engine - Cam Timing Procedure Supplement Page 1682

Engine, Cooling and Exhaust
Engine
Timing Components
Timing Chain / Technical Service Bulletins / Engine - Cam Timing Procedure Supplement
Page 1682

Engine, Cooling and Exhaust
Engine
Timing Components
Timing Chain / Technical Service Bulletins / Engine - Cam Timing Procedure Supplement
Page 1682