Maxima V6-2960cc 3.0L DOHC (VE30DE) (1992)
Air Flow Meter/Sensor: Component Tests and General Diagnostics
Air Flow Meter Test
1.
Pull the rubber insulator back from the air flow meter connector.
2.
Turn the ignition switch ON.
3.
Using a volt meter, check voltage between terminal B and ground.
Voltage should be approximately 0.8 VDC.
4.
Start and warm the engine to operating temperature and then idle it.
5.
Using a volt meter, check voltage between terminal B and ground.
Voltage should be approximately 0.8 - 1.5 VDC.
If the meter fails the above test, check the "hot wire" for dust or damage and replace the meter if necessary.