Maxima V6-2960cc 3.0L SOHC MFI (VG30E) (1990)
Technical Service Bulletin # 91037A
Date: 910606
Bumper - Polyurethane & Polypropylene Fascia Repair
Models
All Models
Section
Body & Frame
Classification
BF91-011a
Bulletin No.
NTB91-037a
Date
June 6, 1991
POLYURETHANE & POLYPROPYLENE
BUMPER FASCIA REPAIR
APPLIED MODELS:
1988-90
Pulsar XE
(KN13)
1990-91
300ZX
(Z32)
1988-89
Pulsar SE
(KN13)
1989-91
240SX
(S13)
1991
Sentra Sdn.
(B13)
1990
Axxess
(M11)
1991
Sentra NX
(KB13)
1988-89
Stanza
(T12)
1989-91
Maxima
(J30)
1990-91
Stanza
(U12)
1988-90
Van
(C22)
SERVICE INFORMATION
This bulletin provides detailed instructions to repair polyurethane and polypropylene bumper fascias. A polyurethane bumper can be distinguished from
a polypropylene bumper by using the following test:
Cut a small piece of material from the end of the bumper fascia and hold it over the flame of a match or lighter until it ignites.
Polyurethane will burn with black smoke and have an odor.
Polypropylene will burn with little smoke and will not have an odor.
Alternate Test:
Sand an area near the damage with a 36 grit disc.
If the material sands cleanly, the bumper is polyurethane.
If the material melts or smears when sanded, it is polypropylene.
Bumper Material Information