Maxima V6-2960cc 3.0L SOHC MFI (VG30E) (1990)
3. Press support bearing assembly off of drive shaft.
4. Separate support bearing from retainer
Inspection
INSPECTION
-
Thoroughly clean all parts in cleaning solvent, and dry with compressed air. Check parts for evidence of deformation or other damage.
Drive shaft
-
Replace drive shaft if it is twisted or cracked.
Boot
-
Check boot for fatigue, cracks, or wear. Replace boot with new boot bands.
Joint assembly
-
Replace joint assembly if it is deformed or damaged.
Support Bearing
-
Make sure wheel bearing rolls freely and is free from noise, cracks, pitting or wear.
Support bearing bracket
-
Check support bearing bracket for cracks with a magnetic exploration or dyeing test.
Assembly and Installation
ASSEMBLY
-
After drive shaft has been assembled, ensure that it moves smoothly over its entire range without binding.
-
Use NISSAN GENUINE GREASE or equivalent after every overhaul.
Wheel side